AML 1 Active Loudspeaker:
It is like no other active monitor available, as every element in the build of the AML 1 is of the highest audiophile grade, from the custom drive units down to the OS-Con capacitors utilised in the key areas of the crossovers and power amplifiers. The AML 1 belies its size and boasts sub-35Hz performance from a modern sculpted compact cabinet.
This monitor has all the virtues of PMC tried and tested transmission line designs, including extremely low distortion with higher SPLs and deeper low frequencies than a traditional ported design of a similar size.
Advantages of the AML 1 over other products are:
-
Accurate and extended low frequency performance
- Lower colouration
- Neutral yet dynamic performance
- Consistent balance at all levels
- Higher SPLs without distortion or compression
- Rakish good looks
The AML 1 employs a flat piston bass driver constructed from a carbon
fibre and Nomex honeycomb which allows large, controlled linear excursions.
A high power handling soft dome unit is used for the high frequencies;
the two drivers are integrated by discrete, low noise active crossovers.
The amplifier and crossover designs are licensed from the high end manufacturer
Bryston. They deliver effortless, clean power whilst preserving neutrality
of balance and image integrity. Bypassable user controls provide for input
level adjustment, LF Roll off, LF tilt and HF tilt.
Subject to change without notice
Specifications
Usable Frequency Response
33Hz - 22kHz
Effective Line Length
1.7 metres (5.5ft)
Crossover
1.4kHz, 24dB/Oct.
Drive Unit Compliment
High Freq: 32mm Soft Dome
Low Freq: 165mm Carbon Fibre & Nomex flat piston
Input Connectors
Balanced XLR3-F, Input Impedance 20k Ohms
IEC Mains(available 100V, 110V-120V, 220V,230V-240V)
Amplifier
Section
- 100W RMS LF Amp, 80W RMS HF Amp
- Distortion < 0.009% from 20Hz to 20kHz full o/p
- Slew Rate > 60V per microsecond
- Power Bandwidth 1Hz to 100kHz
- Signal to noise ratio 90 dB ref. 0dBu.
- Sensitivity 0.775V for 106dB SPL @ 1 Metre
- Power consumption 200W
User
Controls
LF Rolloff (-3dB @ 50Hz, 80Hz, 160Hz)
LF Tilt (@ 30Hz-12dB,-9dB,-6dB,-3dB,+3dB. Knee @ 500Hz)
HF Tilt (@ 10kHz -5dB,2.5dB,+2.5dB. Knee @ 1kHz)
Calibrate switch for EQ defeat
Finish
Slate Grey / Black
Blue / Black
Others available on request
Weight
16 kg Each
Dimensions
Height 400mm
Width 200mm
Depth 316mm